Scientific Troubleshooting for Injection Molders
Scientific Troubleshooting for Injection Molders
 
Alternative Views:


4 Online Courses (6-10 hours)
Our Price: $547.00


Product ID: RT_0251_US

Language




  
Description
 
These four in-depth scientific molding training programs provide participants with the knowledge base required to identify and troubleshoot over twenty-five of the most common injection molded part defects. Users will also come away with a better understanding of how to best process, document and maintain a reliable scientific injection molding process.


Course 1: Introduction

This scientific molding training program focuses on the 7-step process to scientific troubleshooting. Participants are also presented with information and practices on how to best process, document and maintain a reliable scientific injection molding process.

  • Step 1 – Develop a Scientific Molding Process
  • Step 2 – Properly Document the Process Outputs
  • Step 3 – Examine the Defective Part and Rule Out Obvious Causes
  • Step 4 – Compare the Current Process with the Documented Process
  • Step 5 – Return the Process to the Documented Standard
  • Step 6 – Verify the Part and Process
  • Step 7 – Document all Changes Made

Course 2: Visual Defects

Nine of the most common visual defects encountered in injection molding processing are covered within this extensive scientific molding training program. Participants will be better prepared to troubleshoot these defects as each one will be defined and their respective causes and corrections will be explained in detail.

  • Flash
  • Sinks and Voids
  • Short Shots
  • Jetting
  • Gate Blush
  • Burning
  • Flow Lines
  • Weld and Meld Lines
  • Poor Surface Finish

Course 3: Dimensional Defects

This scientific injection molding training program will provide participants with a better understanding of how to best troubleshoot five (5) of the most common dimensional defects encountered in injection molding. Each defect will be defined and their respective causes and corrections will be explained in detail.

  • Large Parts
  • Small Parts
  • Larger Parts at the Gate
  • Smaller Parts at the Gate
  • Warpage

Course 4: Material and Cycle-Related Defects

After completing this scientific molding training program, participants will have a better understanding of how to best identify and troubleshoot many of the most common Material and Cycle-Related defects encountered in injection molding. Each defect will be defined and their respective causes and corrections will be explained in detail.

  • Splay, Bubbles, and Blisters
  • Brittleness, Cracking, and Crazing
  • Delamination
  • Contamination
  • Poor Color Distribution
  • Part Sticking and Ejector Pin Marks
  • Occasional Part Hang-Up

Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

Courses
Courses > Injection Molding
Courses > Injection Molding > Scientific Molding
Scientific Molding Courses